现在的位置: 首页 > 综合 > 正文

Linux下启动httpd服务提示not bind to address

2018年05月26日 ⁄ 综合 ⁄ 共 1172字 ⁄ 字号 评论关闭

这几天在装Apache httpd服务后,启动httpd服务,报错如下:

Starting httpd: httpd: Could not reliably determine the server's fully qualified domain name, using 0.0.0.0 for ServerName
(13)Permission denied: make_sock: could not bind to address [::]:88
(13)Permission denied: make_sock: could not bind to address 0.0.0.0:88
no listening sockets available, shutting down
Unable to open logs             [FAILED]

发现是SELinux在作怪,查看SElinux使用状态

#getenforce

Enforcing

SElinux未禁用。

1、临时禁用SELinux:
# setenforce 0

这样重启服务器之后,还是会启动SELinux;

备注:setenforce 1 临时启用SELinux


2、永久禁用:
打开服务器上的SELinux配置文件,默认为:/etc/selinux/config(还有/etc/sysconfig/selinux),内容如下:

# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
#       enforcing - SELinux security policy is enforced.
#       permissive - SELinux prints warnings instead of enforcing.
#       disabled - SELinux is fully disabled.
SELINUX=enforcing
# SELINUXTYPE= type of policy in use. Possible values are:
#       targeted - Only targeted network daemons are protected.
#       strict - Full SELinux protection.
SELINUXTYPE=targeted

将上面的

SELINUX=enforcing 改为:SELINUX=disable  禁用SeLinux


然后启动httpd服务:

service httpd start

Starting httpd: httpd: Could not reliably determine the server's fully qualified domain name, using 0.0.0.0 for ServerName
                                                         
 [  OK  ]


抱歉!评论已关闭.